2000-2001 FORD FOCUS 4DR W-TYPBODYKIT INSTALLATION INSTRUCTIONS
Download 1) front air dam remove one torx bit screw in each wheel well (front) that secures the inner fender well. Replace it with the 1- 1/12″ screw supplied. Check fit the front air dam on the...
View Article2000-2002 FORD FOCUS ZX3 AVENGER BODY KIT INSTALLATION INSTRUCTIONS
Download Cleaning procedure using a paper towel and grease remover or lacquer thinner, thoroughly clean area on car where the double face tape will come in contact with the painted surface. Do not...
View ArticlePeugeot 306 Roller Bearing Wishbone Bush Kit Installation Guidelines
Download Installation Part Identification Diagram Please refer to diagramsonthefollowing pagesfor identifying parts and terminology. Installation Front Wishbone Bushes 1. Position one of the new solid...
View Article2002 – 2007 Honda CB900F (919 or Hornet 900)
PREPARATION 1. Assemble the brackets to the outside of the fairing mounting area using the M6 x 16 Screws, 5/16” Flat Washers and Nuts supplied with this kit. Figure 1a. Be sure that the round hole...
View Article1960-1965 Ford Falcon Coil Spring IFS Front Suspension Installation Instructions
Download Note: All engine installations with this front end will require a rear sump oil pan. Thank you for choosing TCI Engineering’s Falcon front suspension package. The kit has been designed to not...
View ArticleFord 7.3L 1994-1998 Powerstroke Turbo Diesel Digital Propane Injection
Download Parts Included: 1 – Regulator Assembly 1 – Regulator Mounting Bracket 1 – Propane Lock-off Solenoid 1 – Fuel Pressure Switch 1 – 3-way Pressure Control Solenoid 1 – Propane Pressure Sensor...
View ArticleFord Big (Torino) Bearing Rear Disc Conversion Installation Instructions
Download This kit is for Ford 9″ rear axles with the large Torino (3.15″) style bearing. This kit is designed to work with axles with either GM 5 x 4.75 Bolt Pattern and 7/16″ wheel studs or Ford 5 x...
View ArticleFord 7.3L Power Stroke Rapid Flow Induction Installation Instructions
Download removing the Stock Intake In these steps you will remove the stock intake system. 1. Locate the stock air intake inside the engine bay on the driver side of the vehicle towards the front of...
View ArticleBuick PowerLogger Installation Guide
Download 1) Remove the ECU from the car (it is in the passenger side kick panel). 2) Using ¼” nut driver, remove the 4 screws on the sides of the ECU as well as the 4 on the chip side and chip cover....
View ArticleFORD PERFORMANCE MODULE JET Power Tech Module Installation Instructions
Download ECU Location Chart #1= Behind the passenger kick panel. #2= Under hood on drivers side #3= Driver’s side kick panel, behind emergency brake #4= Under hood, near top of firewall, near passenger...
View Article
More Pages to Explore .....